On 08/06/2018 10:39 PM, Fred wrote:
On 08/06/2018 11:20 AM, Frank Scheiner wrote:
>> [...]
The CDROM drive in my Ultra 10 is attached to IDE channel #2 (the IDE
port farer away from the CPU) and configured as Master device.
And I just now tested with the ISO in question (from 20180516-18:22)
and didn't recognize an issue. Sure, hardware detection takes long on
the Ultra 10, but it eventually succeeds and the CDROM drive is
correctly detected.
>> [...]
Hi Frank,
The MB has only three connectors: floppy, IDE HD and IDE cdrom.
But the two existing IDE ports are not labeled as such on the PCB, there
is J14 which is the second IDE channel and J13 which is the first IDE
channel (both according to [1]). At least that's the case on the system
board PCB of my Ultra 10 and hence I referenced my known good
configuration in this way.