Re: Problem booting T2000 with own kernel (2.6.39) and included initrd

[Denny Schierz <linuxmail@4lin.net>]

hi,

Am 24.02.2012 um 21:46 schrieb Denny Schierz:

> I don't think so, because than DHCP wouldn't work. It seems, that e1000e is used.

tried it, but no success. The kernel uses e1000e

[   59.030919] e1000e: eth3 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[   59.031118] e1000e 0001:07:00.1: eth3: 10/100 speed: disabling TSO
[   59.045931] Sending DHCP and RARP requests ., OK
[   60.554011] IP-Config: Got DHCP answer from 192.168.1.1, my address is 192.168.1.12
[   61.137949] IP-Config: Complete:
[   61.138047]      device=eth3, addr=192.168.1.12, mask=255.255.255.0, gw=192.168.1.1,
[   61.138243]      host=e01, domain=rbgdomain.foo, nis-domain=(none),
[   61.138428]      bootserver=192.168.1.1, rootserver=192.168.1.1, rootpath=/srv/fai-sparc/nfsroot
[   61.138774] Warning: unable to open an initial console.
[   61.144119] Kernel panic - not syncing: Attempted to kill init!
[   61.144242] Call Trace:
[   61.144294]  [000000000045b8f8] do_exit+0xa8/0x6bc
[   61.144344]  [000000000045bf7c] do_group_exit+0x70/0xa8
[   61.144405]  [000000000045bfcc] SyS_exit_group+0x18/0x28
[   61.144472]  [0000000000405fd4] linux_sparc_syscall32+0x34/0x40
[   61.144583] Press Stop-A (L1-A) to return to the boot prom

cu denny