Installing Etch on Sun Ultra 2
Hi folks,
I have a Sun Ultra (Enterprise) 2 and I would like to install Etch on
it.
I have a few questions for you because I'm not used to non-x86 machines
and I'm a little lost.
The CD-ROM drive being out, I must use network install.
I'm sure I will need TFP, ok.
I think I have the choice between DHCP, RARP and BOOTP. Whose is the
best for Etch, a UltraSparc II and a beginner? I think of DHCP.
The PC from which I'll send the boot image is connected to a router.
I think I'll need to connect it directly to the Sun station? Am I wrong?
Here are my first question. ;-)
Sorry for my bad english.
Greetings,
Yannick Palanque
Reply to: