Re: Installing Debian on Netra t1 and A1000

["Morgan Martin-Skerm" <morgan@learnedsolutions.com>]

> The A1000 is not a problem. Debian's primary archive is on an Ultra60
> with an A1000 array. I'm willing to bet you have a SCSI termination
> issue. Try "probe-scsi-all" at the OBP prompt. If you have problems
> there, Linux wont help you.
>

This is the output i get when i use probe-scsi-all at the OBP prompt. What
does this point to? as i said i am really new to all this. please dumb it
down to "chimp level" Target 5 is the storedge rite? but why does it pick up
8 devices when there are only 4 drives connected? can anyone see the problem
here? the "scsi id" dial at the back of the A1000 is set to "5" is this
correct? cheers again

ok probe-scsi-all
/pci@1f,0/pci@1/pci@1/scsi@f,1

/pci@1f,0/pci@1/pci@1/scsi@f
Target 5
  Unit 0   Disk     Symbios StorEDGE A1000  0301
  Unit 1   Device type 20     Symbios StorEDGE A1000  0301
  Unit 2   Device type 20     Symbios StorEDGE A1000  0301
  Unit 3   Device type 20     Symbios StorEDGE A1000  0301
  Unit 4   Device type 20     Symbios StorEDGE A1000  0301
  Unit 5   Device type 20     Symbios StorEDGE A1000  0301
  Unit 6   Device type 20     Symbios StorEDGE A1000  0301
  Unit 7   Device type 20     Symbios StorEDGE A1000  0301

/pci@1f,0/pci@1,1/scsi@2
Target 0
  Unit 0   Disk     SEAGATE ST318203LSUN18G 034A