Re: Debian 3.0 on Netra X1, installs but won't run

[Patrick Morris <trick@adonis.net>]

That may be your problem right there.  If nothing else is on the 
controller, it shouldn't be a master.

Yank all the master/slave/cable select jumpers off and give that a shot.

Marc Singer wrote:

> The CDROM is the master on the second controller.  There is nothing
> else on that chain.
>
> On Tue, Jun 10, 2003 at 12:19:09PM -0700, Andrew Sharp wrote:
>  
>
> > On Mon, Jun 09, 2003 at 07:18:29AM -0700, Marc Singer wrote:
> >    
> >
> > > On Mon, Jun 09, 2003 at 01:05:29PM +0200, Ulrich Teichert wrote:
> > >      
> > >
> > > > How many SCSI-devices are on your bus and how are they wired together?
> > > >
> > > >        
> > > The Netra X1 is an IDE box.  There are two IDE controllers and two
> > > drives.  I pulled one of them and installed an IDE CDROM.
> > >
> > > Now, I'm suspicious of the CDROM since it is the only foreign piece of
> > > hardware.  I've tried a couple without success.  However, if I've been
> > > fortunate enough to install the system, then it appears to be OK when
> > > I remove the CDROM.
> > >      
> > Is it the Master/Slave jumper settings on the CDROM drive?
> >
> > a
> >    
>
>
>