Re: Installing freeS/WAN on 2.4.17
On Fri, Mar 01, 2002 at 04:58:36PM +0100, Michael Blickenstorfer wrote:
> Hi All!
>
> I tried to install freeS/WAN on my UltraSparc IIi.
>
> Here's what I get after rebooting / restarting:
> ---------------------------------------------------------------------
> ipsec_setup: Starting FreeS/WAN IPsec 1.95...
> ipsec_setup: /usr/local/lib/ipsec/tncfg: Socket ioctl failed on attach -- No such device. Is the physical device valid?
> ipsec_setup: SIOCSIFFLAGS: No such device
> ipsec_setup: WARNING: ipsec0 has route filtering turned on, KLIPS may not work
> ipsec_setup: (/proc/sys/net/ipv4/conf/ipsec0/rp_filter = `1', should be 0)
> ipsec_setup: WARNING: eth0 has route filtering turned on, KLIPS may not work
> ipsec_setup: (/proc/sys/net/ipv4/conf/eth0/rp_filter = `1', should be 0)
> ---------------------------------------------------------------------
FreeS/WAN is implementing some ioctl's that sparc64 doesn't know about.
The thing on sparc64 is, you are running 32bit apps under a 64bit
kernel. So the ioctl's have to be translated.
Look in arch/sparc64/kernel/ioctl32.c in the kernel. If you're lucky,
you can simply add the ioctls's as a compatible (meaning no translation
is needed).
--
.----------=======-=-======-=========-----------=====------------=-=-----.
/ Ben Collins -- Debian GNU/Linux -- WatchGuard.com \
` bcollins@debian.org -- Ben.Collins@watchguard.com '
`---=========------=======-------------=-=-----=-===-======-------=--=---'
Reply to: