Re: scsi pci card on ultra10

[Hakan Kuecuekyilmaz <hakan@lisas.de>]

> Well, you loaded SCSI, but it doesn't appear that you loaded the
> driver
> for the SCSI card. Did you build the Adaptect 2940 module at all?
> 
Hello,

after checking the scsi and adaptec drivers I get following at boot:

SCSI subsystem driver Revision: 1.00
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.4
        <Adaptec 2940 SCSI adapter>
        aic7870: Single Channel A, SCSI Id=7, 16/253 SCBs

  Vendor: FUJITSU   Model: M2513A            Rev: 1000
  Type:   Direct-Access                      ANSI SCSI revision: 01
(scsi0:A:5): 5.000MB/s transfers (5.000MHz, offset 10)
Attached scsi removable disk sda at scsi0, channel 0, id 5, lun 0
SCSI device sda: 310352 2048-byte hdwr sectors (636 MB)
sda: Write Protect is off
 sda: sda1 sda2 sda3


But 'mount -t ext2 /dev/sda1 /mnt/test' says:

mount -t ext2 /dev/sda1 /mnt/test
mount: wrong fs type, bad option, bad superblock on /dev/sda1,
       or too many mounted file systems


I made a 'fdisk' and created a sun disklabel with 's' but the parameter rotating
speed [5400] confused me a bit. How can I make a dos or vfat disklabel on it
again, because the machine can read dos formatted floppies.


Any further hints?


thanks alot and regards



--
Hakan Kuecuekyilmaz, presently intern at 
Tecnomatix Technologies Germany | Tel: +49 711 1389- 257
Mittlerer Pfad 9                | <hakan@lisas.de>
70 499 Stuttgart                | <hkuecuekyilmaz@tecnomatix.de>
Studenten, Absolventen und Young Professionals <http://www.c-cn.de>



-------------------------------------------------
This mail sent through IMP: webmail.fht-esslingen.de