2.2r4 installation problems on an Ultra 1 Creator
Can anyone help me with the following installation problem on an
Ultra 1 Creator?
When I try booting from the Potaro 2.2r4 install disk I get the
the welcome screen asking me to choose whether my device is SCSI
or IDE. After choosing 's' the linux kernel boots from the cdrom
but I get the following scsi controller errors:
esp0: IRQ 3,7e0 SCSI ID 7 Clk 40MHz CCF=8 TOut 167 NCR53C9XF(espfast)
ESP: Total of 1 ESP hosts found, 1 actually in use.
scsi0 : Sparc ESP366-HME
scsi : 1 host.
esp0: target 0 [period 100ns offset 15 20.00MHz FAST-WIDE SCSI-II]
esp0: data bad parity detected.
esp0: data bad parity detected.
esp0: yieee, bytes_sent < 0!
esp0: csz=0 fifocount=0 ecount=65464
esp0: use_sg=0 ptr=0000000000aa89
esp0: Forcing async for target 0
scsi0 : channel 0 target 0 lun 0 request sense failed, performing reset.
SCSI bus is being reset for host 0 channel 0.
esp0: Resetting scsi bus
esp0: SCSI bus reset interrupt
esp0: target 0 [period 100ns offset 15 20.00MHz FAST-WIDE SCSI-II]
esp0: data bad parity detected.
esp0: data bad parity detected.
esp0: yieee, bytes_sent < 0!
esp0: csz=0 fifocount=0 ecount=65464
esp0: use_sg=0 ptr=0000000000aa8b40 this_residual=0
esp0: Forcing async for target 0
scsi : aborting command due to timeout : pid 1, scsi0, channel 0, id
0, lun 0 0x 03 00 00 00 10 00
esp0: Aborting command
Subsequently, after a few scsi resets only the cdrom is detected, but
not the hard disk. Does anyone have any idea what might be going on
here? I have been running Solaris 8 without any problems so I know the
hard disk is still good. I have also recently upgraded to OpenBoot
3.25 in case that might be an issue.
Thanks,
David
__________________________________________________
FREE voicemail, email, and fax...all in one place.
Sign Up Now! http://www.onebox.com
Reply to: