FW: is it possible to automatically shut down the box when using poweroff ?
> When I want to shutdown my ultra1, I use the following :
> I use the "shutdown -h now" command on linux: it works fine but after a
> couple of seconds, it show me the prompt ok?, on which I need to key in
> "power-off " to completely switch off the box.
> Is there any way to bypass the second command ( power-off on ok? ), and
> automatically switch off the box after using the shutdown command ??
> Thanks for your time.
Visit us at http://www.clearstream.com
Check out current job vacancies at http://www.clearstream.com/public/english/e_vacs.htm
Internet communications are not secure and therefore Clearstream International does not
accept legal responsibility for the contents of this message.
The information contained in this e-mail is confidential and may be legally privileged. It is
intended solely for the addressee. If you are not the intended recipient, any disclosure,
copying, distribution or any action taken or omitted to be taken in reliance on it, is
prohibited and may be unlawful. Any views expressed in this e-mail are those of the
individual sender, except where the sender specifically states them to be the views of
Clearstream International or of any of its affiliates or subsidiaries.
END OF DISCLAIMER