2.2.1 boot problem - missing scsi disk
I have a system with a Cycle 5 board (Sparc 5 clone) that has two SCSI disks -
targets 3 & 4 with slink installed on both disks. When I boot kernel 2.0.35,
all works fine. But when I install the 2.2.1 kernel on my main disk (target 3)
and then boot, the boot goes fine until where it is scanning the SCSI bus for
disks - and all it sees is target 4, which it then treats as /dev/sda and the
boot sequence fails. When I go back to 2.0.35, all is fine (target 3 is sda,
target 4 is sdb).
Is this a known problem that is fixed in a later version of the 2.2 kernel?
--
Dr. Harry Edmon E-MAIL: harry@atmos.washington.edu
(206) 543-0547 FAX: (206) 543-0308
Dept of Atmospheric Sciences
University of Washington, Box 351640, Seattle, WA 98195-1640
Reply to: