Attempting to boot S/linux Debian version 2.1.9, 03 March, 1999 on a
SPARCstation 1 and
a SPARCstation 10 from CD-ROM loops resetting the esp SCSI controller.
This happened using both the 2.0.35 kernel and the 2.2.1 kernel on the CDROM.
I note that patch-2.2.4 contains changes to drivers/scsi/esp.c - is this
relevant?
If so is there a kernel-2.2.4, 5, or 6 built around somewhere to try?
References from dejanews
Messages 1-5 of exactly 5 matches for search esp0 SCSI bus reset interrupt:
(All in linux.debian.sparc)
Date Scr Subject Author
1. 99/03/16 077 Re: Well... at least it's co Anton Blanchard
2. 99/03/18 075 Re: Well... at least it's co John Heaton
3. 99/03/16 075 Re: Well... at least it's co maxime baudin
4. 99/03/16 065 Well... at least it's consta Lance
5. 99/02/01 065 Very big problem with 2.2.1 Nagy Attila
One of the above mentions problems with specific SCSI CD-ROM drives. The same
original Sun single-spin drive was attached to both machines. Will try my old
double spin
Toshiba 3401.
Please add to the bug register if relevant.
Summarized capture - full capture in attachment below
SPARCstation 10 (1 X 390Z50), No Keyboard
ROM Rev. 2.7, 48 MB memory installed, Serial #6303243.
Ethernet address 8:0:20:12:c:1d, Host ID: 72602e0b.
Rebooting with command: cdrom
Boot device: /iommu/sbus/espdma@f,400000/esp@f,800000/sd@6,0:d File and args:
SILO
Welcome to Debian GNU/Linux 2.1!
..
This disk uses Linux 2.0.35 (from kernel-image-2.0.35_2.0.35-4)
Press <ENTER> to boot!
boot:
linux linux-2.2
boot: linux-2.2
Loading initial ramdisk....
PROMLIB: obio_ranges 5
Booting Linux...
PROMLIB: Sun Boot Prom Version 3 Revision 2
Linux version 2.2.1 (root@fatneck) (gcc version 2.7.2.3) #1 Sun Feb 28 18:57:45
EST 1999
ARCH: SUN4M
TYPE: Sun4m SparcStation10/20
Ethernet address: 8:0:20:12:c:1d
Boot time fixup v1.6. 4/Mar/98 Jakub Jelinek (jj@ultra.linux.cz). Patching
kernel for srmmu[TI Viking]/iommu
[0]: v[f0000000,f1000000](1000000) p[00000000]
[1]: v[f4000000,f5000000](1000000) p[04000000]
[2]: v[fc000000,fcf4c000](f4c000) p[0c000000]
[3]: v[fcf4d000,fcf60000](13000) p[0cf4d000]
SRMMU: Compact physical memory. Using strightforward VA<->PA translations.
Found CPU 0 <node=ffd490e0,mid=8>
Found 1 CPU prom device tree node(s).
Power off control detected.
Calibrating delay loop... 35.94 BogoMIPS
Memory: 43480k available (1260k kernel code, 2688k data, 124k init)
[f0000000,fd000000]
VFS: Diskquotas version dquot_6.4.0 initialized
POSIX conformance testing by UNIFIX
IOMMU: impl 0 vers 1 page table at fcec0000 of size 262144 bytes
sbus0: Clock 18.0 MHz
dma0: Revision 2
dma1: Revision 2
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
Initializing RT netlink socket
Starting kswapd v 1.5
Sparc Zilog8530 serial driver version 1.38
tty00 at 0xffede004 (irq = 44) is a Zilog8530
tty01 at 0xffede000 (irq = 44) is a Zilog8530
tty02 at 0xffedb004 (irq = 44) is a Zilog8530
tty03 at 0xffedb000 (irq = 44) is a Zilog8530
keyboard: not present
Console: ttyS0 (Zilog8530)
Sun Mouse-Systems mouse driver version 1.00
RAM disk driver initialized: 16 RAM disks of 4096K size
loop: registered device at major 7
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
esp0: IRQ 36 SCSI ID 7 Clk 40MHz CCF=8 TOut 167 NCR53C9XF(espfast)
ESP: Total of 1 ESP hosts found, 1 actually in use.
scsi0 : Sparc ESP100A-FAST
scsi : 1 host.
Vendor: SEAGATE Model: ST1480 SUN0424 Rev: 7516
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 1, lun 0
Vendor: SEAGATE Model: ST1480 SUN0424 Rev: 7516
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 3, lun 0
Vendor: SONY Model: CD-ROM CDU-8012 Rev: 3.1e
Type: CD-ROM ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
esp0: disconnect, resetting bus
esp0: Resetting scsi bus
esp0: SCSI bus reset interrupt
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: Resetting scsi bus
esp0: SCSI bus reset interrupt
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: Resetting scsi bus
esp0: SCSI bus reset interrupt
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: Resetting scsi bus
esp0: SCSI bus reset interrupt
esp0: SCSI bus reset interrupt
SPARCstation 1, No keyboard.
ROM Rev. 1.3, 16 MB memory installed, Serial #53435.
Ethernet address 8:0:20:8:78:f7, Host ID: 5100d0bb.
boot sd(0,6,0)
Booting from: sd(0,6,0)
SILO
Welcome to Debian GNU/Linux 2.1!
..
This disk uses Linux 2.0.35 (from kernel-image-2.0.35_2.0.35-4)
Press <ENTER> to boot!
boot:
linux linux-2.2
boot: linux
Loading initial ramdisk....
.u$e.
.$$$$$:S
$"*$/"*$$
$.`$ . ^F
4k+#+T.$F
4P+++"$"$
:R"+ t$$B
___# $$$
| | R$$k
dd. | Linux $!$
ddd | Sparc $9$F
'!!!!!$ !!#!`
!!!!!* .!!!!!`
'!!!!!!!W..e$$!!!!!!` 2.0.35
"~^^~ ^~~^
PROMLIB: Sun Boot Prom Version 0 Revision 0
ARCH: SUN4C
TYPE: Sun4c SparcStation 1
Ethernet address: 8:0:20:8:78:f7
Loading sun4c MMU routines
SUN4C: 63 mmu entries for the kernel
sbus0: Clock 25.0 MHz
dma0: Revision 1
zs0: console I/O
Calibrating delay loop.. ok - 19.92 BogoMIPS
Memory: 13168k available (1072k kernel code, 1120k data) [f0000000,f3400000]
Swansea University Computer Society NET3.035 for Linux 2.0
NET3: Unix domain sockets 0.13 for Linux NET3.035.
Swansea University Computer Society TCP/IP for NET3.034
IP Protocols: IGMP, ICMP, UDP, TCP
VFS: Diskquotas version dquot_5.6.0 initialized
Linux version 2.0.35 (root@dianne) (gcc version 2.7.2.3) #1 Wed Feb 17 20:37:03
CET 1999
Starting kswapd v 1.4.2.2
Sparc Zilog8530 serial driver version 1.18.2.15
tty00 at 0xffd02004 (irq = 12) is a Zilog8530
tty01 at 0xffd02000 (irq = 12) is a Zilog8530
tty02 at 0xffd00004 (irq = 12) is a Zilog8530
tty03 at 0xffd00000 (irq = 12) is a Zilog8530
keyboard: not present
Sun Mouse-Systems mouse driver version 1.00
Ramdisk driver initialized : 16 ramdisks of 4096K size
loop: registered device at major 7
Floppy drive(s): fd0 is 1.44M
FDC 0 is an 82072A
md driver 0.36.3 MAX_MD_DEV=4, MAX_REAL=8
esp0: IRQ 3 SCSI ID 7 Clock 20 MHz CCF=4 Time-Out 167 NCR53C90(esp100) detected
ESP: Total of 1 ESP hosts found, 1 actually in use.
scsi0 : Sparc ESP100 (NCR53C90)
scsi : 1 host.
Vendor: MAXTOR Model: LXT-213S SUN0207 Rev: 4.17
Type: Direct-Access ANSI SCSI revision: 01 CCS
Detected scsi disk sda at scsi0, channel 0, id 3, lun 0
Vendor: SONY Model: CD-ROM CDU-8012 Rev: 3.1e
Type: CD-ROM ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
esp0: disconnect, resetting bus
esp0: resetting bus...
esp0: SCSI bus reset interrupt
Attachment:
sparcstation-1,10-slink-esp-loop.txt.gz
Description: Binary data