Re: s390 Etch install problem
On Sep 7, 2:10 pm, Bastian Blank <wa...@debian.org> wrote:
> On Fri, Sep 07, 2007 at 01:28:09PM -0700, GaryR wrote:
> > Kernel command line: root=/dev/ram0 ip=off ro debian-installer/
> > locale=C
>
> This is wrong. Neither root= nor ip= is listed in the supplied parmfile.
> The content is:
> | ro debian-installer/locale=C
>
> > checking if image is initramfs...it isn't (bad gzip magic numbers);
>
> Your initrd file is broken.
>
> Bastian
>
> --
> Those who hate and fight must stop themselves -- otherwise it is not stopped.
> -- Spock, "Day of the Dove", stardate unknown
>
> --
> To UNSUBSCRIBE, email to debian-s390-REQU...@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
Initrd is supplied by Debian, but it is broken, but I can't use an
initrd, but must use an initramfs?! I've tried downloading initrd's
from several different ftp sites with same result. Also, I started
out with the default parmfile and no go. In fact, anything I put into
parmfile gives same result. Where can I get a proper initramfs? Or,
how can I get this booted?
Reply to: