Bug#959075: Still not working on Debian testing

[richard lucassen <mailinglists@lucassen.org>]

On Sun, 05 Jul 2020 09:58:46 +0800
Paul Wise <pabs@debian.org> wrote:

> > Rereading it, I don't know if this issue was present in 2.9 or
> > earlier. I just noticed it while testing the new version.
> 
> Would you mind downgrading to 2.9 and testing it?
> You can install it from Debian buster or snapshot.d.o

No message indeed:

# wget
http://ftp.nl.debian.org/debian/pool/main/i/ifenslave/ifenslave_2.9_all.deb

# ifdown bond0

# modprobe -rv bonding

# dpkg --purge ifenslave

# dpkg -i ifenslave_2.9_all.deb

# ifup bond0
#

(no message)

# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v5.7.0-1-amd64

Bonding Mode: fault-tolerance (active-backup)
Primary Slave: eth2 (primary_reselect always)
Currently Active Slave: eth2
MII Status: up
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0
Peer Notification Delay (ms): 0
ARP Polling Interval (ms): 2000
ARP IP target/s (n.n.n.n form): 10.234.0.33, 10.234.0.34

Slave Interface: eth2
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 90:b1:1c:33:94:d8
Slave queue ID: 0

Slave Interface: eth3
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 90:b1:1c:33:94:d9
Slave queue ID: 0

-- 
richard lucassen
https://contact.xaq.nl/