Bug#959075: Still not working on Debian testing
Debian testing:
$ dpkg -l | grep ifenslave
ii ifenslave 2.10+nmu2
all configure network interfaces for parallel routing (bonding)
The lines "bond-slaves" and "bond-primary" still do not work:
iface bond0 inet static
address 10.234.0.32
netmask 255.255.255.0
network 10.234.0.0
broadcast 10.234.0.255
bond-slaves eth2 eth3
bond-mode active-backup
bond-primary eth2
bond-arp_interval 2000
bond-arp_ip_target 10.234.0.33, 10.234.0.34
# ifup bond0
#
# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v5.7.0-1-amd64
Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: None
MII Status: down
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0
Peer Notification Delay (ms): 0
ARP Polling Interval (ms): 2000
ARP IP target/s (n.n.n.n form): 10.234.0.33, 10.234.0.34
I miss the slaves eth2 and eth3, so I add them by manually:
# echo "+eth2" > /sys/class/net/bond0/bonding/slaves
# echo "+eth3" > /sys/class/net/bond0/bonding/slaves
[or:]
# ip link set eth2 master bond0
# ip link set eth3 master bond0
# echo eth2 > /sys/class/net/bond0/bonding/primary
# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v5.7.0-1-amd64
Bonding Mode: fault-tolerance (active-backup)
Primary Slave: eth2 (primary_reselect always)
Currently Active Slave: eth2
MII Status: up
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0
Peer Notification Delay (ms): 0
ARP Polling Interval (ms): 2000
ARP IP target/s (n.n.n.n form): 10.234.0.33, 10.234.0.34
Slave Interface: eth2
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 90:b1:1c:33:94:d8
Slave queue ID: 0
Slave Interface: eth3
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 90:b1:1c:33:94:d9
Slave queue ID: 0
--
richard lucassen
http://contact.xaq.nl/
Reply to: