Re: firewire CD-ROM
On Thu, 2004-12-02 at 09:46 +0100, Sebastian Henschel wrote:
> hello Adam...
>
> * Adam Done <mlist@donestudios.com> [2004-12-02 09:24 +0100]:
> > I have a firewire drive working great on my system but now I have
> > installed a firewire Lacie external CD burner and I see that Linux
> > recognize it when I dmsg.
> >
> > PCI: Enabling device 0001:11:03.0 (0004 -> 0005)
> > ieee1394: Initialized config rom entry `ip1394'
> > ohci1394: $Rev: 1223 $ Ben Collins <bcollins@debian.org>
> > PCI: Enabling device 0001:11:0a.0 (0010 -> 0012)
> > ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[63]
> > MMIO=[80080000-800807ff] Max Packet=[2048]
> > ieee1394: Node added: ID:BUS[0-00:1023] GUID[00d04b01070340de]
> > ieee1394: Node added: ID:BUS[0-01:1023] GUID[00d001010000a2fd]
> > ieee1394: Host added: ID:BUS[0-03:1023] GUID[000a27fffeda4b94]
> > SCSI subsystem initialized
> > sbp2: $Rev: 1219 $ Ben Collins <bcollins@debian.org>
> > scsi0 : SCSI emulation for IEEE-1394 SBP-2 Devices
> > ieee1394: sbp2: Node 0-00:1023: Using 36byte inquiry workaround
> > ieee1394: sbp2: Logged into SBP-2 device
> > ieee1394: Node 0-00:1023: Max speed [S400] - Max payload [2048]
> > Vendor: LACIE Model: CDBP-241040A Rev: 6.34
> > Type: CD-ROM ANSI SCSI revision:
> > 02
> > scsi1 : SCSI emulation for IEEE-1394 SBP-2 Devices
>
> > sr0: scsi3-mmc drive: 16x/40x writer cd/rw xa/form2 cdda tray
> ^^^
> here it is.
>
> > Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
> > ieee1394: sbp2: Logged into SBP-2 device
> > ieee1394: Node 0-01:1023: Max speed [S400] - Max payload [2048]
> > Vendor: FireWire Model: 1394 Disk Drive Rev:
> > Type: Direct-Access ANSI SCSI revision:
> > 02
> > SCSI device sda: 11733120 512-byte hdwr sectors (6007 MB)
> > sda: cache data unavailable
> > sda: assuming drive cache: write through
> > sda: [mac] sda1 sda2 sda3 sda4 sda5 sda6 sda7 sda8 sda9
> > Attached scsi disk sda at scsi1, channel 0, id 0, lun 0
> > PHY ID: 406212, addr: 0
> >
> >
> >
> > I also looked at /proc/scsi/scsi:
> >
> > Attached devices:
> > Host: scsi0 Channel: 00 Id: 00 Lun: 00
> > Vendor: LACIE Model: CDBP-241040A Rev: 6.34
> > Type: CD-ROM ANSI SCSI revision:
> > 02
> > Host: scsi1 Channel: 00 Id: 00 Lun: 00
> > Vendor: FireWire Model: 1394 Disk Drive Rev:
> > Type: Direct-Access ANSI SCSI revision:
> > 02
> >
> >
> >
> > What I can't figure out is what sd device the cdrw is located at. Dmesg
> > tells me it is there. Has anyone else have any light on this subject.
> > Thanks in advance.
>
> have you tried /dev/sr0 for accessing the device?
I had to chuckle to my self, I was looking for sd(x) for the device and
totally over looked the sr0.
I got the drive to read cdroms but under gnome nautilus it does not
reconize the device to write. The dmesg says:
scsi1 : SCSI emulation for IEEE-1394 SBP-2 Devices
sr0: scsi3-mmc drive: 40x/40x writer cd/rw xa/form2 cdda tray
/dev shows
l cdrom*
lrwxrwxrwx 1 root root 3 Nov 28 21:31 cdrom -> hdc
lrwxrwxrwx 1 root root 3 Dec 2 02:09 cdrom1 -> sr0
lrwxrwxrwx 1 root root 3 Dec 2 02:11 cdrom2 -> hdc
-adam
Reply to: