Re: Kernel 2.4.20-ben7 not booting on my iBook 500
> Hrm... It's an ATI r128 (M3) based ibook or radeon (M6 or M7) based one ?
it's an ATI r128.
> Can you try adding "printkbtext" to the kernel command line and tell
> me what messages are displayed before the crash and what is the
> exact message displayed last ? Also make sure you do a clean build.
The last messages are about "probing PCI hardware".
I can't really tell which one is the last, because it wraps around
on the bottom of the screen.
And with ben6 I get a lot of network errors like:
<7>udp v4 hw csum failure.
<7>hm tcp v4 csum failed.
lspci -v of the graphics card:
00:10.0 VGA compatible controller: ATI Technologies Inc Rage Mobility M3
(rev 02) (prog-if 00 [VGA])
Subsystem: ATI Technologies Inc Rage Mobility M3 AGP 2x
Flags: bus master, stepping, 66Mhz, medium devsel, latency 255, IRQ 48
Memory at 94000000 (32-bit, prefetchable) [size=64M]
I/O ports at 802400 [size=256]
Memory at 90000000 (32-bit, non-prefetchable) [size=16K]
Expansion ROM at 90020000 [disabled] [size=128K]
Capabilities:  AGP version 2.0
Capabilities: [5c] Power Management version 2