PowerBook G4 III and Airport
Sorry, but I'm back! I've got my Airport card installed and the airport module loaded, but I can't connect to my Belkin F5D6130 WAP. I've tried fiddling with every permutation of switches on iwconfig but to no avail. Any thoughts anybody.
I've included the output from dmesg, iwconfig, /proc/net/wireless if this helps.
Many thanks,
Andrew
dmesg trace:
hermes.c: 5 Apr 2002 David Gibson <hermes@gibson.dropbear.id.au>
orinoco.c 0.11b (David Gibson <hermes@gibson.dropbear.id.au> and others)
airport.c 0.11b (Benjamin Herrenschmidt <benh@kernel.crashing.org>)
eth1: Station identity 001f:0001:0004:0010
eth1: Looks like a Lucent/Agere firmware version 4.16
eth1: Ad-hoc demo mode supported
eth1: MAC address 00:30:65:04:9B:96
eth1: Station name "HERMES I"
eth1: ready
airport: card registered for interface eth1
powerg4:~# iwconfig eth1
Warning: Driver for device eth1 has been compiled with version 14
of Wireless Extension, while this program is using version 15.
Some things may be broken...
eth1 IEEE 802.11-DS ESSID:"WLAN" Nickname:"HERMES I"
Mode:Managed Frequency:2.422GHz Access Point: 44:44:44:44:44:44
Bit Rate:2Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Power Management:off
Link Quality:0/92 Signal level:134/153 Noise level:134/153
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
powerg4:~# cat /proc/net/wireless
Inter-| sta-| Quality | Discarded packets | Missed
face | tus | link level noise | nwid crypt frag retry misc | beacon
eth1: 0000 0. 134. 134. 0 0 0 0 0 0
Reply to: