2.4 kernel on a 6500
I will soon compile the 2.4 kernel on my 6500. I have two questions:
1. A while ago (the last time I did this) I had to configure for USB
support in order to use the new input layer, even though the 6500
doesn't have USB. Is this still the case?
2. I'm pretty sure I must configure support for via-cuda, but do I need
to also choose support for pmu?
Thanks very much for the help. Also, I looked all over for doc's
on the new input layer before writing this, but every link to "Franzo's
Blurb on the New Input Layer" gets me 404/Not Found. Are there other
good places to look?