Re: xfree86 and mouse
On Wed, May 30, 2001 at 03:28:45AM -0800, Ethan Benson wrote:
> On Wed, May 30, 2001 at 01:56:08PM +0200, morten wrote:
> > hi again
> >
> > Now I have it working ... my first debian system on my first powermac - seen
> > this way it really is to invite problems.
> >
> > I have installed task-x-window-system and I run X, but it complains that it
> > cannot open the mouse. In XF86conf it is set to busmouse on /dev/mouse. This is
> > apparently not correct - any suggestions.
>
> rtfla
>
> X11: protocol=IMPS/2
> gpm: protocol=ps2
FYI, gpm supports imps2 protocol now. This is with version 1.19.3 on my PPC.
gpm -t help
...
ps2 (PS/2) - For most PS/2 mice (round with 6 metal pins).
fups2 (PS/2) - For BROKEN PS/2 mice (round with 6 metal pins).
...
imps2 - For wheel mice on a PS/2 port (round connector with 6
pins), 3 buttons (wheel is repeated).
fuimps2 - For BROKEN wheel mice on a PS/2 port
(round connector with 6 pins), 3 buttons (wheel is repeated).
I guess it won't matter unless you're using it in repeater mode, since gpm
doesn't do anything with the wheel, AFAIK.
--
#define X(x,y) x##y
Peter Cordes ; e-mail: X(peter@llama.nslug. , ns.ca)
"The gods confound the man who first found out how to distinguish the hours!
Confound him, too, who in this place set up a sundial, to cut and hack
my day so wretchedly into small pieces!" -- Plautus, 200 BCE
Reply to: