[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: ieee1394 *and* new input layer in one kernel



Bryan Stillwell <bstill@terraplex.com> writes:

> >So I grabbed 2.4.0-test11 off rsynch from linuxcare. It built the
> >ieee1394 with no trouble, but when I rebooted, I didn't have a
> >keyboard or a mouse -- no new input layer support, and all my input
> >device files in /dev have been switched over.
> 
> Am I to understand that you have a ieee1394 hard drive working under ppc
> linux?  This weekend I was able to get all the ieee1394 stuff working
> with 2.2.18pre21 from Paulus's tree, but I didn't have anything to test
> with besides gscanbus which seemed to be working fine.  I tried testing
> with the eth1394 driver, but I haven't been able to get it to compile
> yet.  :(

I was unable to successfully use 2.2.18 with ieee1394. It compiled and
I could use libraw1394 and gscanbus without any devices attached, but
by attaching my harddrive gscanbus would be stuck in a read() and
never exit. Killing gscanbus killed linux. 

I have built 2.4.0-test11 and will see if I can get sbp2 to work
properly. 

jas.



Reply to: