Re: Problem installing on RaQ 2
Hi,
Yes the DHCP server i'm using is setup to give the correct information, I use the server on my LAN to distribue IP's. I do have a firebox firewall running however i've added an outgoing rule to allow full access to it.
I have been monitoring networking traffic using wireshark and once the files have been recieved by the cobalt all network traffic dies. Before I select start the install via SSH I can ping the cobalts IP address however once I start the install i can no longer ping it.
Regards
On 8/30/07, Martin Michlmayr <tbm@cyrius.com> wrote:
* Jason Yates <jasonyates07@googlemail.com> [2007-08-30 00:17]:
> I am currently trying to install debian-mips on a RaQ 2. I have got
> it to boot from the NFS server, selected the SSH install method
> however it just hangs at the starting SSH installer message, from
> reading a tutorial I understand that it'd only supposed to take a
> few minutes at most however after 30 minutes nothing has changed. I
> have restarted the process several times.
Is your DHCP server configured properly? In particular, does your
Cobalt receive information about the router (gateway) and DNS via
DHCP? If it doesn't, the Cobalt will wait forever until you enter
this information but obviously you cannot do that because there's no
shell yet.
--
Martin Michlmayr
http://www.cyrius.com/
--
Kind Regards,
Jason Yates
*****************************************
This email and any files transmitted with it are confidential and may be
legally privileged. It is intended solely for the addressee. Access to this
email by anyone else is unauthorized. If you are not the intended recipient,
any disclosure, copying, distribution or any action taken or omitted to be
taken in reliance on it, is prohibited and may be unlawful.
*****************************************
Reply to: