Re: debian-mips 3.1on O2, arcboot: IO error, arcboot: no such device

["os junkie" <liniks@hotmail.com>]

Thiemo Seufer wrote:
> os junkie wrote:
> > Good evening all,
> >
> > I'm trying to load debian (3.1R4) on an SGI O2 with 64MB.
> >
> > The TFTP boot works like a charm, net install goes exactly as expected,
> > but after all is said and done, when I reboot and enter my 4
> > "setenv..." lines, I get the following error:
> >
> > SCSI Hard Error on (0,1) unexpected bus free (hastat 0x13) --check
> > cabling
> > cbd: 12 0 0 0 1 0
> >
> > <above line occurs 5 times, identical, then the next errors:>
> >
> > Unable to execute scsi(0)disk(1)rdisk(0)partition(8)/arcboot:  IO error
> > Unable to load scsi(0)disk(1)rdisk(0)partition(8)/arcboot: no such
> > device.
> >
> > I've done the load twice, just in case I typo'd somewhere, with the
> > exact same results.  My setenv lines were taken from the closing
> > instructions in the load and are as follows:
> >
> > setenv SystemPartition scsi(0)disk(1)rdisk(0)partition(8)
> > setenv OSLoadPartition scsi(0)disk(1)rdisk(0)partition(0)
>
> I think this should be prefixed with the pci spec:
>
> setenv SystemPartition pci(0)scsi(0)disk(1)rdisk(0)partition(8)
> setenv OSLoadPartition pci(0)scsi(0)disk(1)rdisk(0)partition(0)
>
>
> Thiemo
>
>
> --
> To UNSUBSCRIBE, email to debian-mips-REQUEST@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org

To no avail, same error with pci(0) prepended to the above setenv
lines.  <sigh>

Thanks, 

David