Re: kernel 2.6.19 + Cisco 350 Wireless adapter needs manual config

[Florian Kulzer <florian@molphys.leidenuniv.nl>]

On Thu, Jan 18, 2007 at 20:07:59 +0100, Mauro Darida wrote:
> On Tuesday 16 January 2007 12:13, Florian Kulzer wrote:
> > Then try
> >
> > /sbin/ifconfig
> ifi:~# /sbin/ifconfig
> eth0      Link encap:Ethernet  HWaddr 08:00:46:90:DC:AA
>           UP BROADCAST MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
>           Interrupt:10 Base address:0x8800
> 
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           UP LOOPBACK RUNNING  MTU:16436  Metric:1
>           RX packets:16 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:16 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
>           RX bytes:800 (800.0 b)  TX bytes:800 (800.0 b)

[ It would help if you kept the other relevant information in the
  thread. How are people supposed to help you if they do not know the
  context of this message? ]

I assume that eth0 is not the Cisco wireless adapter. Check if you can
see the Cisco adapter with "ls -l /sys/class/net/". If no device is
created even after you do "modprobe airo" then something is probably
broken with your udev. Did you restore /etc/udev and /etc/hotplug like I
suggested in my earlier mail?

-- 
Regards,
          Florian