Resume from S3 breaks console
Hello everybody,
debian-laptop has no answer so I'm trying here...
This is the last issue I have with Debian Sid and my HP Omnibook. It resumes correctly from suspend-to-ram (S3) to X, but the console shows green dancing squares and the resolution is dropped to 640x480. I can type blindly to it and I can switch back to X, but that's about all I can do.
What I have tried already:
1. 'reset' ... yeah, right ... if it would be that simple ...
2. No framebuffer: this is worse. X has some 3 or 4 bad vertical lines and switching to console hangs the whole system.
3. atyfb with various parameters: The same bad lines in X. I can type blindly in the console and go back to X. Trying to change resolution with 'fbset' will crush the system.
This is my setup:
Stock kernel 2.6.15-1-686 with vga=792 acpi_sleep=s3_bios
^^^^^^^^^^^^^^^^^^
without this, X would have a black screen
$lspci -v
[snip]
0000:01:00.0 VGA compatible controller: ATI Technologies Inc Rage Mobility P/M AGP 2x (rev 64) (prog-if 00 [VGA])
Subsystem: Hewlett-Packard Company: Unknown device 0010
Flags: bus master, stepping, medium devsel, latency 66, IRQ 10
Memory at f5000000 (32-bit, non-prefetchable) [size=16M]
I/O ports at 9000 [size=256]
Memory at f4100000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at 38000000 [disabled] [size=128K]
Capabilities: [50] AGP version 1.0
Capabilities: [5c] Power Management version 1
[snip]
Any suggestions how to reset the console?
Andrei
--
If you can't explain it simply, you don't understand it well enough. (Albert Einstein)
Reply to: