Re: using a beamer: resolution?
On Wed, 2004-05-12 at 16:35 +0200, David Fokkema wrote:
> Hi group,
>
> >From time to time, I use a beamer on my external VGA port of my laptop.
> My laptop TFT panel has a resolution of 1400x1050 pixels but the beamer
> has a resolution of only 800x600. However, it can support 1024x768 using
> software scaling. Right now I have to edit my XF86Config-4 by hand and
> then restart my X server. The problem is that X does recognize the
> beamer on the external port and does switch back to a lower resolution,
> but the viewport stays at 1400x1050, not very handy. Does anybody know
> of an easy solution?
The RandR extension in XFree86 4.3 and later supports this (resolution
switch and resize desktop to match) and there are toolbar doodads
(gnome-randr-applet) you can get that let you control the switch with a
few mouseclicks.
I used this on my old laptop, but it would only switch between 1600x1200
and 1280x1024 but that was a driver (or X config) issue - I know the
Vesa driver let me switch between 1600x1200 all the way down to 640x480.
Regards,
Andrew.
-------------------------------------------------------------------------
Andrew @ Catalyst .Net .NZ Ltd, PO Box 11-053, Manners St, Wellington
WEB: http://catalyst.net.nz/ PHYS: Level 2, 150-154 Willis St
DDI: +64(4)916-7201 MOB: +64(21)635-694 OFFICE: +64(4)499-2267
What are they doing now? http://schoolreunions.co.nz/
-------------------------------------------------------------------------
Reply to: