pcmcia, CardBus eth0 was working, now it's not seen?
I'm running debian woody 3.0, 2.4.18-bf2.4.
I havent used this laptop in a while but i just
started again. Before i stopped using it, it had a really
bad crash, i could boot to single user mode only, any other
runlevel it would crash. I graduately began turning on
services and trying runlevels till it was running again.
Now that i haven't used it in awhile, i'm having this problem,
it doesn't seem to see its network device (eth0) anymore,
The pcmcia drivers are loading fine, i don't see tulip.c anymore.
but the lspci error is what worries me, it's hard to get
specific troubleshooting info without it, any ideas?
prompt> ifconfig eth0
eth0: error fetching interface information: Device not found
prompt> sudo lspci -vv
pcilib: Cannot open /proc/bus/pci/15/00.0
lspci: Unable to read 64 bytes of configuration space.
prompt> ls -l /proc/bus/pci
total 0
dr-xr-xr-x 2 root root 0 Apr 14 22:46: 00
-r--r--r-- 1 root root 0 Apr 14 22:46: devices
prompt> dmesg | less
[snip]
Kernel command line: BOOT_IMAGE=Linux-2.4.18-bf ro root=303 pci=biosirq
PCI: No IRQ known for interrupt pin A of device 00:13.0. Please try using pci=biosirq.
PCI: No IRQ known for interrupt pin B of device 00:13.1. Please try using pci=biosirq.
Toshiba ToPIC97 rev 20 PCI-to-CardBus at slot 00:13, mem 0x10000000
host opts [0]: [slot 0xd0] [ccr 0x11] [cdr 0x86] [rcr 0x02] [no pci irq]
[lat 168/176] [bus 20/20]
host opts [1]: [slot 0xd0] [ccr 0x21] [cdr 0x86] [rcr 0x02] [no pci irq]
[lat 168/176] [bus 21/21]
ISA irqs (default) = 3,4,5,7,9,10,12 polling interval = 1000 ms
cs: cb_alloc(bus 21): vendor 0x13d1, device 0xab00
cs: cb_free(bus 21)
cs: cb_alloc(bus 21): vendor 0x13d1, device 0xab00
[/snip]
I would appreciate any ideas or info, thanks
-mus
Reply to: