Re: Linux-wlan-ng vs. kernel/pcmcia-cs drivers...
Since there was no response to this message I went ahead and installed
pcmcia-cs by hand.
I first did an apt-get dist-upgrade to sarge, from there I install gcc
components and other stuff for compiling C/C++ code.
I then downloaded kernel-source-2.4.20(with debian kernel patches) and
pcmcia-source via apt-get.
Next I created a generic kernel without PCMCIA support.
Just make xconfig; make dep; make mzImage; make modules; make modules_install;
cp arch/i386/boot/bzImage /boot/vmlinuz-2.4.20-generic, then edit your
boot manager script to test new kernel.
After the first shot I had the debian 2.4.20 kernel installed and running
fine. Next I compiled pcmcia-cs from -sarge which is version 3.1.34.
I did a make config; make all; make install and it compile with errors but
still worked.
With my entry in /etc/pcmcia/wireless.opts looking like this:
*,*,*,*)
INFO="Zippi"
ESSID="SlakNet"
MODE="managed"
CHANNEL="1"
RATE="11M auto"
KEY="xxxx-xxxx-xx"
;;
I experience very poor performance. my max speed was about 8.6Kb/ps.
So I compiled pcmcia-cs v3.2.4 from http://pcmcia-cs.sf.net, this time it
compiled with no errors. I rebooted and now I am getting in the
nieghborhood of 600Kb/ps threwput.
I hope this helps somebody, maybe when I have a bit more time I can dine
in to the linux-wlan-ng driver and see what it has to offer.
So far my experience with kernel-2.4.20+deb-pkgs and pcmcia-cs-3.2.4 has
been good, my only complaint left is the dmesg reports this error about
75 times since putting the card in and writing this email:
eth0: Error -5 writing packet to BAP
eth0: Error -5 writing packet to BAP
eth0: Error -5 writing packet to BAP
Any suggestions or questions are appreciated and welcome.
* * * * * * * *
Matt Snow
(@) drama@slakin.net
(w) http://slakin.net.
"We do not tell others the things we fear admitting to ourselves."
-w0rd
On Fri, 4 Apr 2003, Darryl L. Pierce wrote:
> On Fri, Apr 04, 2003 at 12:45:15PM -0800, Matt Snow wrote:
> <snip>
> > Also please send replys to me as I am not on the list.
>
> Send them here as well, since I have the same card and interest...
>
> --
> Darryl L. Pierce <mcpierce@databasix.com>
> Visit the Infobahn Offramp - <http://bellsouthpwp.net/m/c/mcpierce>
> "What do you care what other people think, Mr. Feynman?"
>
Reply to: