IR & Serial Port Problems
I have an IBM ThinkPad 600 and currently I have to use the windows utility to disable the IR port and enable the serial
port. Once in a great while on reboot the system will restore it's bios settings back to default and the IR port is
turned back on. I then have to go through the process again of setting up the windows partition again. I have tpctl
and ThinkPad base but the power says error. Below are the readouts for tpctl --rsx the top is working serial the bottom
is working IR no serial. Please assist
com1 on
resource state: ioaddr irq# able? mode/power
serial port 1: 0x3f8 IRQ4 enable on
serial port 2: 0x0 IRQ0 disable
com1 off
resource state: ioaddr irq# able? mode/power
serial port 1: 0x0 IRQ0 disable (error)
serial port 2: 0x3f8 IRQ4 enable
Reply to: