Error reports on my WAN pc-card Belkin with Netgear ME102 AP
Hi,
As some of you may have noted I had some problems with my Belkin card.
However I finally got it going..averything seems ok although perhaps a bit
sluggish at times.
In my syslog I have the following errors
-----------------
kernel: eth1: Tx error, status 1 (FID=01F1)
kernel: eth1: Tx error, status 1 (FID=017C)
kernel: eth1: Tx error, status 1 (FID=0551)
kernel: eth1: Tx error, status 1 (FID=049B)
kernel: eth1: Tx Error -110 writing packet header to BAP
kernel: eth1: Tx error, status 1 (FID=03C8)
kernel: eth1: Unknown Rx error (0x3). Frame dropped
kernel: eth1: Unknown Rx error (0x3). Frame dropped
kernel: eth1: Undecryptable frame on Rx. Frame dropped
------
Does anyone have any idea what is causing this? The last message I guess is
an encryption problem although i dont seem to understand why.
In my AP's firmware I have noted that when setting encryption keys (64 or
128) you have to define four keys. One key is the default key. There is
also an option called "Open systen", and one "Shared"
I have discovered that if I enable 64 bit encryption and enable Shared then
my card cannot communicate with the AP. However if my card has encryption
set and the AP has Open enabled it works - with errors generated above. If
i turn off encryption in my pc-card then it cannot communicate with the AP.
Anyway, I would be very glad if anyone had an idea as to the problem here.
Thomas
Reply to: