compaq presario 900z IRQ routing troubles with 2.4.x kernels
Hi!
I am trying to get a 2.4 kernel running on my compaq presario 900z. So far
the only kernel I got running on this is 2.2 which comes with debian
installer (output from lspci-vv from it is attached).
I tried prebuilt 2.4.19-k7 from unstable and self-built 2.4.19 , 2.4.20-rc2
and currently I am at 2.4.20-rc2-ac1 all with no success. The behaviour I
was getting varied ( for example I had it hang right after it said
"Partition check:" ).
Right now what I have is that after the message "NET4: Unix domain sockets
... " I am getting the following:
-------
hda: status timeout: status=0xd0 { Busy }
hda: drive not ready for command
...
ide0: reset timed-out, status=0xd0
-----
(this is repeated several times with fs messages about not being able to
read superblock)
....and finally:
-------
Kernel panic: VFS: Unable to mount root fs on 03:02
-------------
earlier I get these messages, which suggest to me that there is a problem
with interrupts:
-----
....
IRQ routing conflict for 00:08.0, have irq 5, want irq 4
.....
PCI: No IRQ known for interrupt pin ? of device 00:0a.0. Please try using
pci=biosirq
yenta 00:0a.0: Preassigned resource 0 busy, reconfiguring...
yenta 00:0a.0: Preassigned resource 1 busy, reconfiguring...
yenta 00:0a.0: Preassigned resource 2 busy, reconfiguring...
yenta 00:0a.0: Preassigned resource 3 busy, reconfiguring...
Yenta IRQ list 0000, PCI irq0
....
----------------------
and also (not sure this is related):
-----
spurious 8259A interrupt: IRQ7.
-----
any ideas as to what is happening and how to fix it?
Would it be a good idea to forward this to kernel-dev?
thanks for the help
--
fedor.
----
"I've seen better heads on half a pint of beer."
00:00.0 Host bridge: ATI Technologies Inc: Unknown device cab0 (rev 13)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort+ >SERR- <PERR-
Latency: 64
Region 0: Memory at f8000000 (32-bit, prefetchable)
Region 1: Memory at f4400000 (32-bit, prefetchable)
Region 2: I/O ports at 8090 [disabled]
Capabilities: <available only to root>
00:01.0 PCI bridge: ATI Technologies Inc: Unknown device 700f (rev 01) (prog-if 00 [Normal decode])
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 99
Bus: primary=00, secondary=01, subordinate=01, sec-latency=68
I/O behind bridge: 00009000-00009fff
Memory behind bridge: f4100000-f41fffff
Prefetchable memory behind bridge: f6000000-f7ffffff
Secondary status: SERR
BridgeCtl: Parity- SERR- NoISA+ VGA+ MAbort- >Reset- FastB2B-
00:02.0 USB Controller: Acer Laboratories Inc. [ALi] USB 1.1 Controller (rev 03) (prog-if 10 [OHCI])
Subsystem: Acer Laboratories Inc. [ALi] USB 1.1 Controller
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (20000ns max)
Interrupt: pin A routed to IRQ 11
Region 0: Memory at f4010000 (32-bit, non-prefetchable)
Capabilities: <available only to root>
00:07.0 ISA bridge: Acer Laboratories Inc. [ALi] M1533 PCI to ISA Bridge [Aladdin IV]
Subsystem: Acer Laboratories Inc. [ALi] ALI M1533 Aladdin IV ISA Bridge
Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0
Capabilities: <available only to root>
00:08.0 Multimedia audio controller: Acer Laboratories Inc. [ALi] M5451 PCI AC-Link Controller Audio Device (rev 02)
Subsystem: Compaq Computer Corporation: Unknown device 00b0
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR+ <PERR+
Interrupt: pin A routed to IRQ 5
Region 0: I/O ports at 8400
Region 1: Memory at f4011000 (32-bit, non-prefetchable)
Capabilities: <available only to root>
00:0a.0 CardBus bridge: Texas Instruments PCI1410 PC card Cardbus Controller (rev 02)
Subsystem: Compaq Computer Corporation: Unknown device 00b0
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32
Interrupt: pin A routed to IRQ 0
Region 0: Memory at ffbfe000 (32-bit, non-prefetchable)
Bus: primary=00, secondary=00, subordinate=00, sec-latency=0
Memory window 1: fbbfd000-ffbfc000 (prefetchable)
I/O window 0: 00000000-00000003
I/O window 1: 00000000-00000003
BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset+ 16bInt+ PostWrite-
16-bit legacy interface ports at 03e1
00:0b.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C (rev 20)
Subsystem: Compaq Computer Corporation: Unknown device 00b0
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (8000ns min, 16000ns max), cache line size 10
Interrupt: pin A routed to IRQ 11
Region 0: I/O ports at 8800
Region 1: Memory at f4013000 (32-bit, non-prefetchable)
00:0c.0 Communication controller: Conexant HSF 56k HSFi Modem (rev 01)
Subsystem: Compaq Computer Corporation: Unknown device 8d88
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 10
Region 0: Memory at f4000000 (32-bit, non-prefetchable)
Region 1: I/O ports at 8098
Capabilities: <available only to root>
00:0f.0 USB Controller: Acer Laboratories Inc. [ALi] USB 1.1 Controller (rev 03) (prog-if 10 [OHCI])
Subsystem: Acer Laboratories Inc. [ALi] USB 1.1 Controller
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 11
Region 0: Memory at f4012000 (32-bit, non-prefetchable)
Capabilities: <available only to root>
00:10.0 IDE interface: Acer Laboratories Inc. [ALi] M5229 IDE (rev c4) (prog-if fa)
Subsystem: Acer Laboratories Inc. [ALi] M5229 IDE
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (500ns min, 1000ns max)
Interrupt: pin A routed to IRQ 0
Region 4: I/O ports at 8080
Capabilities: <available only to root>
00:11.0 Bridge: Acer Laboratories Inc. [ALi] M7101 PMU
Subsystem: Acer Laboratories Inc. [ALi] ALI M7101 Power Management Controller
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
01:05.0 VGA compatible controller: ATI Technologies Inc: Unknown device 4336 (prog-if 00 [VGA])
Subsystem: Compaq Computer Corporation: Unknown device 00b0
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR- FastB2B+
Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 66 (2000ns min), cache line size 10
Interrupt: pin A routed to IRQ 10
Region 0: Memory at f6000000 (32-bit, prefetchable)
Region 1: I/O ports at 9000
Region 2: Memory at f4100000 (32-bit, non-prefetchable)
Capabilities: <available only to root>
Reply to: