[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Unidentified subject!

Mark Janssen :

> What did you do when installing the drivers... follow the readme
> closely.
Yes (make;make install-amr).

> What does lspci -v -v -v show on the modem
It show:

00:01.6 Modem: Silicon Integrated Systems [SiS]: Unknown device 7013 (rev a0)
(prog-if 00 [Generic])
        Subsystem: CLEVO/KAPOK Computer: Unknown device 2202
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR+ FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 128 (13000ns min, 2750ns max)
        Interrupt: pin C routed to IRQ 10
        Region 0: I/O ports at 3600 [size=256]
        Region 1: I/O ports at 3800 [size=128]
        Capabilities: [48] Power Management version 2
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=55mA
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

> What does lsmod show

> Are all the modem-modules loaded

> Is the device-file created

> can you run minicom using the device-file

With lsmod i d'ont see the modules loaded (slmdm;slamrmo), i load it by hand, i
checked that the device-file was created, i run minicom and the system blocks...



Reply to: