On Sat, Nov 24, 2001 at 11:22:34 +0100, Philip Iezzi <debian@iezzi.ch> wrote: [...] > I'm using the loadlin from install.bat to load the bootdisks. windows leaves the built-in eepro100 in a quite wonky state. by default, you can't use the eepro100 after a softboot after windows. there is a tool at donald beckers site to reset the chip (pcisomehting). > I need to do a network installation. After selecting and loading the > correct module for my built-in network card (eepro100), I'm trying to > start to install the base system. That's where my machine get's stuck. i never managed to do a network install after loadlin on my Z505 (same HW, but US version). i just copied the base system over to the windows partition, installed from there, and after a hard reboot the eepro100 worked fine. [...] > Other people didn't run into that problem with the same machine and I > got a friend who's running woody on a Z600NE. It definately neet to > get this going, but I'm almost giving up i'm pretty sure your friend didn't do a netboot during install. or at least not after softbooting from windows. -- Thomas 'Mike' Michlmayr | ignorami: n: The BOFH art of folding problem <mike+sig@cluon.priv.at> | lusers into representational shapes.
Attachment:
pgplQT60Bw98s.pgp
Description: PGP signature