Xircom Ethernet/Modem problem
I have a Dell Lattitude CP with a Xircom 33k6 Eth/modem combo. I installed
slink with no problems. The card is recognised and configured properly and
the ethernet device works.
Problem is the modem. I can see no errors in the syslog file (attached), but
sending ATZ to the modem has no effect.
I read some HOWTO's and README files, but have not found the problem or the
solution.
Does this ring a bell to you, or have you got any suggestions where to look?
please tell me!
Greating,
Ben Mesman.
--- Part of syslog ---
Nov 5 09:15:07 nl1019 cardmgr[103]: starting, version is 3.0.5
Nov 5 09:15:07 nl1019 cardmgr[103]: watching 2 sockets
Nov 5 09:15:07 nl1019 kernel: cs: IO port probe 0x1000-0x17ff: excluding
nothing: probe failed.
Nov 5 09:15:07 nl1019 kernel: cs: IO port probe 0x0100-0x04ff: excluding
0x210-0x217 0x220-0x22f 0x290-0x297 0x378-0x37f 0x388-0x38f 0x4d0-0x4d7
Nov 5 09:15:07 nl1019 kernel: cs: IO port probe 0x0a00-0x0aff: clean.
Nov 5 09:15:07 nl1019 kerneld: started, pid=110, qid=0
Nov 5 09:15:07 nl1019 cardmgr[103]: initializing socket 0
Nov 5 09:15:07 nl1019 kernel: cs: memory probe 0xa0000000-0xa0ffffff:
clean.
Nov 5 09:15:07 nl1019 cardmgr[103]: socket 0: Xircom CEM33 Ethernet/Modem
Nov 5 09:15:07 nl1019 cardmgr[103]: executing: 'insmod
/lib/modules/2.0.36/pcmcia/xirc2ps_cs.o'
Nov 5 09:15:07 nl1019 kernel: xirc2ps_cs.c 1.29 1998/04/27 19:20:19
(dd9jn+kvh)
Nov 5 09:15:07 nl1019 cardmgr[103]: executing: 'insmod
/lib/modules/2.0.36/pcmcia/serial_cs.o'
Nov 5 09:15:07 nl1019 kernel: eth0: Xircom: port 0x2d0, irq 3, hwaddr
00:80:C7:74:30:DC
Nov 5 09:15:07 nl1019 kernel: tty03 at 0x02e8 (irq = 3) is a 16450
Nov 5 09:15:07 nl1019 cardmgr[103]: executing: './network start eth0'
Nov 5 09:15:09 nl1019 kernel: eth0: switching to 10BaseT port
Nov 5 09:15:09 nl1019 kernel: eth0: media 10Base2, silicon revision 1
Nov 5 09:15:10 nl1019 kernel: eth0: media 10Base2, silicon revision 1
Nov 5 09:15:10 nl1019 cardmgr[103]: executing: './serial start ttyS3'
Nov 5 09:20:50 nl1019 kernel: registered device ppp0
Nov 5 09:20:50 nl1019 pppd[192]: pppd 2.3.5 started by root, uid 0
Nov 5 09:20:51 nl1019 chat[193]: abort on (BUSY)
Nov 5 09:20:51 nl1019 chat[193]: abort on (NO CARRIER)
Nov 5 09:20:51 nl1019 chat[193]: abort on (VOICE)
Nov 5 09:20:51 nl1019 chat[193]: abort on (NO DIALTONE)
Nov 5 09:20:51 nl1019 chat[193]: abort on (NO ANSWER)
Nov 5 09:20:51 nl1019 chat[193]: send (ATZ^M)
Nov 5 09:20:51 nl1019 chat[193]: expect (OK)
Nov 5 09:21:36 nl1019 chat[193]: alarm
Nov 5 09:21:36 nl1019 chat[193]: Failed
Nov 5 09:21:36 nl1019 pppd[192]: Connect script failed
Nov 5 09:21:37 nl1019 pppd[192]: Exit.
---End---
Reply to: