Re: knoppix-installer -> slow system
Hi,
Felix Miata a écrit :
I ran knoppix-installer with the default debian option on a K6/2 550 VIA
MVP4 system that seemed to run just fine off the 4.0.2 CD, but things
aren't so great running off the HD. The first time I let it run any
length of time it ground to a halt with out of memory, 256M real, and
384M virtual.
Never seen this kind of message.
During boot it seems like it loads every module for every
device ever made. /etc/modules is 601 bytes. /etc/modules.conf is 15,384
bytes.
You should look at /etc/modules-2.6.12
(/etc/modules-`uname -r`)
most could be disabled because they are loaded by hotplug.
Somes needn't to be loaded (pcmcia , ieee1394 ...) depending of your
hardware config.
How do I trim these files down and speed up
this system?
You will speed up start but don't think it will speed up use.
Also, how do I set portmap to automatically start in
runlevel 2+ (chkconfig in rpm systems makes this easy)?
You can run kysyv or update-rc.d
I think you have to check DMA with hdparm (but it should be enabled by
default)
You have to disable some daemon.
But It's strange that live is speeder than hd-install.
Did you look at "load" field in top output ?
Hope it helps you a bit.
--
Jody
Reply to: