Bug#658759: Also on Guruplug

[Donald Gordon <don@dis.org.nz>]

I've seen what looks like the same issue on my Guruplug.
linux-image-3.1.0-1-kirkwood (3.1.8-2) boots fine,
linux-image-3.2.0-1-kirkwood (3.2.2-1) doesn't get anywhere.

My U-boot banner looks like this:

----
U-Boot 2011.03 (Apr 26 2011 - 21:35:00)
Marvell-GuruPlug

SoC:   Kirkwood 88F6281_A1
DRAM:  512 MiB
NAND:  512 MiB
In:    serial
Out:   serial
Err:   serial
Net:   egiga0, egiga1
88E1121 Initialized on egiga0
88E1121 Initialized on egiga1
----

And when I boot 3.2.0-1, this is what I see:

----
Loading file "/uImage.bak" from ide device 0:1 (hda1)
1570456 bytes read
Loading file "/uInitrd.bak" from ide device 0:1 (hda1)
8211832 bytes read


Marvell>> bootm 0x00800000 0x01100000
## Booting kernel from Legacy Image at 00800000 ...
   Image Name:   Debian kernel

   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1570392 Bytes = 1.5 MiB
   Load Address: 00008000
   Entry Point:  00008000
   Verifying Checksum ... OK
## Loading init Ramdisk from Legacy Image at 01100000 ...
   Image Name:   Debian ramdisk
   Image Type:   ARM Linux RAMDisk Image (gzip compressed)
   Data Size:    8211768 Bytes = 7.8 MiB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.
----

After this, no more messages are visible on the serial console, and
there is no other indication that the boot progresses.

Thanks

donald