Bug#599021: eth0 stops working after a bit of traffic

[karl156 <karl156@abwesend.de>]

Thank you :)

Am 04.10.2010 00:06, schrieb Ben Hutchings:
> On Mon, 2010-10-04 at 00:01 +0200, karl156 wrote:
>>> Please send the output of 'lspci -vnn'.  And in future, use reportbug to
>>> send bug reports, as this will gather that information automatically.
>>>
>>> Ben.
>>>
> [...]
>> 01:02.0 Ethernet controller [0200]: D-Link System Inc DL2000-based
>> Gigabit Ethernet [1186:4000] (rev 0c)
>>         Subsystem: D-Link System Inc DL2000-based Gigabit Ethernet
>> [1186:4000]
>>         Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 23
>>         I/O ports at b400 [size=256]
>>         Memory at ff0fbc00 (32-bit, non-prefetchable) [size=512]
>>         Expansion ROM at ff0e0000 [disabled] [size=64K]
>>         Capabilities: [50] Power Management version 2
>>         Kernel driver in use: dl2k
> [...]
> 
> OK, you have a device which should be handled by dl2k not ipg.  The fix
> for this is simple and will be included in the next upload to unstable.
> As a workaround until then, you can blacklist the ipg driver.
> 
> Ben.
>