Bug#399537: linux-image-2.6.17-2-k7: USB: CDROM causes CF card nondetection
Package: linux-image-2.6.17-2-k7
Version: 2.6.17-6
Severity: minor
At boot, I notice that if I have a CDROM writer (only tested when
empty) plugged in to USB, my card reader's 128MB CF card is not
detected, only the 16 MB built-in card is. I must unplug and replug
the card reader to get the 128 MB card detected. Problem happens on
-686 kernel too. Here are some dmesg excerpts.
device-mapper: 4.6.0-ioctl (2006-02-17) initialised: dm-devel@redhat.com
Vendor: PHILIPS Model: DVDR1648P1 Rev: P1.2
Type: CD-ROM ANSI SCSI revision: 00
usb-storage: device scan complete
sr0: scsi3-mmc drive: 48x/48x writer cd/rw xa/form2 cdda tray
Uniform CD-ROM driver Revision: 3.20
sr 1:0:0:0: Attached scsi CD-ROM sr0
sr 1:0:0:0: Attached scsi generic sg0 type 5
Vendor: Generic Model: USB Storage-SMC Rev: 0180
Type: Direct-Access ANSI SCSI revision: 00
0:0:0:0: Attached scsi generic sg1 type 0
usb-storage: device scan complete
SCSI device sda: 32001 512-byte hdwr sectors (16 MB)
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 32001 512-byte hdwr sectors (16 MB)
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
sda: sda1
sd 0:0:0:0: Attached scsi removable disk sda
usb 1-1.1.1: USB disconnect, address 4
usb 1-1.1.1: new full speed USB device using uhci_hcd and address 6
usb 1-1.1.1: configuration #1 chosen from 1 choice
scsi2 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 6
usb-storage: waiting for device to settle before scanning
Vendor: Generic Model: USB Storage-SMC Rev: 0180
Type: Direct-Access ANSI SCSI revision: 00
SCSI device sda: 32001 512-byte hdwr sectors (16 MB)
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 32001 512-byte hdwr sectors (16 MB)
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
sda: sda1
sd 2:0:0:0: Attached scsi removable disk sda
sd 2:0:0:0: Attached scsi generic sg1 type 0
Vendor: Generic Model: USB Storage-CFC Rev: 0180
Type: Direct-Access ANSI SCSI revision: 00
SCSI device sdb: 250369 512-byte hdwr sectors (128 MB)
sdb: Write Protect is off
sdb: Mode Sense: 00 00 00 00
sdb: assuming drive cache: write through
SCSI device sdb: 250369 512-byte hdwr sectors (128 MB)
sdb: Write Protect is off
sdb: Mode Sense: 00 00 00 00
sdb: assuming drive cache: write through
sdb: sdb1
sd 2:0:0:1: Attached scsi removable disk sdb
sd 2:0:0:1: Attached scsi generic sg2 type 0
Vendor: Generic Model: USB Storage-MMC Rev: 0180
Type: Direct-Access ANSI SCSI revision: 00
sd 2:0:0:2: Attached scsi removable disk sdc
sd 2:0:0:2: Attached scsi generic sg3 type 0
Vendor: Generic Model: USB Storage-MSC Rev: 0180
Type: Direct-Access ANSI SCSI revision: 00
sd 2:0:0:3: Attached scsi removable disk sdd
sd 2:0:0:3: Attached scsi generic sg4 type 0
usb-storage: device scan complete
We also notice goofy repeating of messages. udev, hal is installed.
Reply to: