Bug#334398: Acknowledgement (kernel-image-2.6.12-1-k7: Filesystem corruption with sata_sil)
More infomation I should have included the first time:
IDE Controller
Silicon Image 3112 - PCi:1095:3112 (rev 02)
HardDisk : Seagate ST380013AS
I note that there seemed to be some trouble with trouble with
the combo upstream. I tried a raw destructive badblocks scan
on the drive and got about 10% of the drive back.
Interestingly enough the seems to be a 'harmonic pattern' to the
bad blocks.
eg.
perl -ne 'my $diff=$_-$last; $last=$_; print "$diff\n"' sda.bad
contains a lot of repeated patterns like:
1
1
6
24
8
24
(I've atatched this output as it's gzip substationally better than the
raw list. And the raw list can be reconstructed from it.).
Useful ( --dmesg | grep -A2 -B2 -E '(ata)|(ide)'--) dmesg output:-
Linux version 2.6.12-1-k7 (horms@tabatha.lab.ultramonkey.org) (gcc
version 4.0.2 20050917 (prerelease) (Debian 4.0.1-8)) #1 Tue Sep 27
13:22:07 JST 2005
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000017ff0000 (usable)
BIOS-e820: 0000000017ff0000 - 0000000017ff8000 (ACPI data)
BIOS-e820: 0000000017ff8000 - 0000000018000000 (ACPI NVS)
BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved)
--
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 381472k/393152k available (1692k kernel code, 11128k reserved,
721k data, 176k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode...
Ok.
Calibrating delay loop... 1474.56 BogoMIPS (lpj=737280)
--
SELinux: Disabled at boot.
Mount-cache hash table entries: 512
CPU: After generic identify, caps: 0183f9ff c1c7f9ff 00000000 00000000
00000000 00000000 00000000
CPU: After vendor identify, caps: 0183f9ff c1c7f9ff 00000000 00000000
00000000 00000000 00000000
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 64K (64 bytes/line)
--
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
Boot video device is 0000:01:00.0
PCI: Using IRQ router VIA [1106/0686] at 0000:00:07.0
VFS: Disk quotas dquot_6.5.1
--
NET: Registered protocol family 1
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
VP_IDE: IDE controller at PCI slot 0000:00:07.1
PCI: Via IRQ fixup for 0000:00:07.1, from 255 to 0
--
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci0000:00:07.1
ide0: BM-DMA at 0xff00-0xff07, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xff08-0xff0f, BIOS settings: hdc:DMA, hdd:DMA
Probing IDE interface ide0...
hda: SAMSUNG SV0221H, ATA DISK drive
hdb: Maxtor 52049U4, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Probing IDE interface ide1...
hdc: IDE DVD-ROM 16X, ATAPI CD/DVD-ROM drive
hdd: SONY CD-RW CRX320E, ATAPI CD/DVD-ROM drive
ide1 at 0x170-0x177,0x376 on irq 15
Probing IDE interface ide2...
Probing IDE interface ide3...
Probing IDE interface ide4...
Probing IDE interface ide5...
hda: max request size: 128KiB
hda: 39179952 sectors (20060 MB) w/2048KiB Cache, CHS=38869/16/63,
UDMA(100)
hda: cache flushes supported
/dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4 < p5 p6 p7 >
hdb: max request size: 128KiB
hdb: 40020624 sectors (20490 MB) w/2048KiB Cache, CHS=39703/16/63,
UDMA(66)
hdb: cache flushes not supported
/dev/ide/host0/bus0/target1/lun0: p1 p2
EXT3-fs: INFO: recovery required on readonly filesystem.
EXT3-fs: write access will be enabled during recovery.
kjournald starting. Commit interval 5 seconds
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
Adding 682752k swap on /dev/hda3. Priority:-1 extents:1
EXT3 FS on hda1, internal journal
--
eth0: RealTek RTL8139 at 0xbc00, 00:08:a1:00:20:d3, IRQ 10
eth0: Identified 8139 chip type 'RTL-8139C'
libata version 1.11 loaded.
sata_sil version 0.9
PCI: Found IRQ 5 for device 0000:00:09.0
ata1: SATA max UDMA/100 cmd 0xD88BCE80 ctl 0xD88BCE8A bmdma 0xD88BCE00
irq 5
ata2: SATA max UDMA/100 cmd 0xD88BCEC0 ctl 0xD88BCECA bmdma 0xD88BCE08
irq 5
input: ImPS/2 Generic Wheel Mouse on isa0060/serio1
ata1: dev 0 cfg 49:2f00 82:346b 83:7d01 84:4003 85:3469 86:3c01 87:4003
88:207f
ata1: dev 0 ATA, max UDMA/133, 156301488 sectors: lba48
ata1(0): applying Seagate errata fix
ata1: dev 0 configured for UDMA/100
scsi0 : sata_sil
ata2: no device found (phy stat 00000000)
scsi1 : sata_sil
Vendor: ATA Model: ST380013AS Rev: 3.05
Type: Direct-Access ANSI SCSI revision: 05
TTFN
--
Roger. Home| http://www.sandman.uklinux.net/
Master of Peng Shui. (Ancient oriental art of Penguin Arranging)
Work|Independent Sys Consultant | http://www.computer-surgery.co.uk/
New key Fpr: 1227 ABB1 7545 77A7 6816 2D18 4EBC AA9B 8EE3 1DD3
Reply to: