Re: Errore di smartd
mauro morichi <mauro@teppisti.it> writes:
> Il 11/11/2023 16:04, Leandro Noferini ha scritto:
>
> /dev/disk/by-id/ata-WDC_WD40EFRX-68WT0N0_WD-WCC4E1LFNRRT [SAT] :
> Usage: Seek_Error_Rate (7) changed to
> 200, 100, 200,
>
> dalla knowledge base di acronis:
>
> Seek Error Rate S.M.A.R.T. parameter indicates a rate of seek errors of the magnetic heads. In case of a failure in the mechanical positioning system, a
> servo damage or a thermal widening of the hard disk, seek errors arise.
>
> Recommendations
>
> Although this parameter is not considered critical by the most hardware vendors, degradation of this parameter may indicate electromechanical
> problems of the disk. Regular backup is recommended. If no other (critical) parameters report a problem, hardware replacement is recommended on
> mission critical systems only.
Sembra un po' una diagnosi da medico poco propenso alle spiegazioni ma
mi pare di aver capito che non mi devo proccupare :)
Grazie un monte!
--
Ciao
leandro
Reply to: