Re: ethernet to parallel/serial converter

[emilio brambilla <emilio@newsland.it>]

hello,

look at TS100 in this page:
http://www.cyclades.com/products/2/ts_series

it's 100% linux based and you can also (cross)compile additional 
software; it costs a few hundreds of euros

Leonardo Boselli wrote:
> Sorry for an hardware question:
> I would need a [_relatively_ cheap and small] device with the following 
> capabilities:
>  a. one ethernet input
>  b. at least 16 bit of output 
> This device should be addressed as a normal ethernet device, with a 
> standard tcp stack, yopu just send two or more byte that would apopear 
> on the output.
> optionally one byte of input .
> End of requirement
> Someone has helps to do or even a project to build it ?
> (even an USB one would fit)
>
>    --
> Leonardo Boselli
> Nucleo Informatico e Telematico del Dipartimento Ingegneria Civile
> Universita` di Firenze , V. S. Marta 3 - I-50139 Firenze
> tel +39 0554796431 cell +39 3488605348 fax +39 055495333
> http://www.dicea.unifi.it/~leo

--
Bye,
emilio