..gw route setup, tieing to the right nic fails
Hi,
..I though adding routes to interfaces would tie them to the
relevant interfaces? What am I doing wrong here?:
gw:~# cat /etc/network/interfaces
# /etc/network/interfaces -- configuration file for ifup(8), ifdown(8)
# The loopback interface
auto lo
iface lo inet loopback
# The first network card - this entry was created during the Debian
# installation
# (network, broadcast and gateway are optional)
auto eth0 eth1 eth2 eth3
iface eth0 inet static
address A.B.C.E
netmask 255.255.255.224
network A.B.C.D
broadcast A.B.C.Z
up route add -net A.B.G.0 netmask 255.255.255.128 gw A.B.C.F
up route add -net A.B.H.128 netmask 255.255.255.128 gw A.B.C.G
iface eth1 inet static
address A.B.H.1
netmask 255.255.255.128
network A.B.H.0
broadcast A.B.H.127
up route add -net 192.168.x.0 netmask 255.255.255.0 gw A.B.C.H
up route add -net 192.168.y.0 netmask 255.255.255.0 gw A.B.C.H
iface eth2 inet static
address I.J.K.M
netmask 255.255.255.224
network I.J.K.L
broadcast I.J.K.T
iface eth3 inet static
address K.L.M.P
netmask 255.255.255.252
network K.L.M.N
broadcast K.L.M.Q
gateway K.L.M.O
gw:~# route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
K.L.M.N 0.0.0.0 255.255.255.252 U 0 0 0 eth3
A.B.C.D 0.0.0.0 255.255.255.224 U 0 0 0 eth0
I.J.K.L 0.0.0.0 255.255.255.224 U 0 0 0 eth2
A.B.H.0 0.0.0.0 255.255.255.128 U 0 0 0 eth1
A.B.H.128 A.B.C.F 255.255.255.128 UG 0 0 0 eth0
A.B.G.0 A.B.C.G 255.255.255.128 UG 0 0 0 eth0
192.168.x.0 A.B.C.H 255.255.255.0 UG 0 0 0 eth0
192.168.y.0 A.B.C.H 255.255.255.0 UG 0 0 0 eth0
0.0.0.0 K.L.M.O 0.0.0.0 UG 0 0 0 eth3
gw:~#
--
..med vennlig hilsen = with Kind Regards from Arnt... ;-)
...with a number of polar bear hunters in his ancestry...
Scenarios always come in sets of three:
best case, worst case, and just in case.
Reply to: