Re: I cant connect to an ISP
Well...
There are my if-config...
lo Link encap:Local Loopback
inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0
eth0 Link encap:Ethernet HWaddr 00:00:B4:A5:21:4C
inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0
Interrupt:11 Base address:0x6100
ppp0 Link encap:Point-to-Point Protocol
inet addr:200.188.4.236 P-t-P:200.188.0.103 Mask:255.255.255.0
UP POINTOPOINT RUNNING MTU:1500 Metric:1
RX packets:14 errors:0 dropped:0 overruns:0 frame:0
TX packets:22 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0
Memory:222c038-222cc04
And...
the route -n...
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
200.188.0.103 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 200.188.0.103 0.0.0.0 UG 0 0 0 ppp0
Well...
I cant see some anormality at if-config and route...
As i had told, i doesnt use a script to connect to internet... I use WVDIAL...
Well, one day on past, i had used a script... But with no sucess..
Maybe this problem will be caused by some configuration on Kernel?
>why not send the list a report of the output of:
>
>ifconfig
>route -n
>
>Also what does your chat script look like that connects you to the web?
>
Rafael Riedel
-=Side=-
http://netwinsite.com
Reply to: