Re: Booting The Debian GNU/Hurd get locked
Yuval,
Have you run ./native-install twice?
Phil.
On Thu, 20 Jan 2005, Yuval Tanny wrote:
> Hello,
>
>
> After following this:
>
> http://www.debian.org/ports/hurd/hurd-install
>
> installation guide, I get this message at boot:
>
> (this is what I see on the screen)
>
>
> ide0 at 0x1f0-0x1f7, 0x3f6 on irq 14
>
> ide1 at 0x170-0x177, 0x3f6 on irq 15
>
> Floppy...
>
> FDC is a post 1991 82077
>
> Failed initialization of WD-7000 SCSI card!
>
> EATAO, address 0x1f0 in use skipping probe.
>
> EATAO, address 0x170 in use skipping probe.
>
> ppa: Version 1.42
>
> ppa: Probing port 03bc
>
> ppa: Probing port 0378
>
> ...(and some other lines from ppa)..
>
> scsi: 0 hosts.
>
> scsi: detected total.
>
> rtl8139.c:B1.23a ...
>
> http:///www...
>
> eth0: RealTek RTL81396 Fast Ethernet at 0xa00 IRQ 10, 0:e0:ud: 7:98:ca
>
> Now the system lock. It's not responding.
>
>
> I installed from debian-gnu-hurd-2004.12.30.tar.gz. I have ABIT NF7-S
> (nforce 2 with SCSI controller that is in no use) motherboard, WD800JB
> hard disc (ATA connected), the Debian GNU/Hurd is on hda1or hd0s1 (I
> hope :-) ), It's a 6 GB (maybe this is it?) ext2 hurd partition.
>
>
> What is the problem and how can I fix it?
>
>
> I'll be glade to give more info,
>
> Thanks,
>
> Yuval
>
>
> --
> To UNSUBSCRIBE, email to debian-hurd-REQUEST@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
>
>
--
Philip Charles; 39a Paterson Street, Abbotsford, Dunedin, New Zealand
+64 3 488 2818 Fax +64 3 488 2875 Mobile 025 267 9420
philipc@copyleft.co.nz - preferred. philipc@debian.org
I sell GNU/Linux & GNU/Hurd CDs & DVDs. See http://www.copyleft.co.nz
Reply to: