[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Booting The Debian GNU/Hurd get locked

No. I didn't run it at all. The guide say: "Once you are presented with a shell prompt, and any time that the Hurd is in single user mode, it is necessary to set the terminal type:". I hadn't presented with a shell prompt in the GNU/Hurd system, yet. Should I chroot to in and run it (twice?)?

(I'm not using the K8 installer...)



Philip Charles wrote:

	Have you run ./native-install twice?


On Thu, 20 Jan 2005, Yuval Tanny wrote:


After following this:


installation guide, I get this message at boot:

(this is what I see on the screen)

ide0 at 0x1f0-0x1f7, 0x3f6 on irq 14

ide1 at 0x170-0x177, 0x3f6 on irq 15


FDC is a post 1991 82077

Failed initialization of WD-7000 SCSI card!

EATAO, address 0x1f0 in use skipping probe.

EATAO, address 0x170 in use skipping probe.

ppa: Version 1.42

ppa: Probing port 03bc

ppa: Probing port 0378

...(and some other lines from ppa)..

scsi: 0 hosts.

scsi: detected total.

rtl8139.c:B1.23a ...


eth0: RealTek RTL81396 Fast Ethernet at 0xa00 IRQ 10, 0:e0:ud: 7:98:ca

Now the system lock. It's not responding.

I installed from debian-gnu-hurd-2004.12.30.tar.gz. I have ABIT NF7-S
(nforce 2 with SCSI controller that is in no use) motherboard, WD800JB
hard disc (ATA connected), the Debian GNU/Hurd is on hda1or hd0s1 (I
hope :-) ), It's a 6 GB (maybe this is it?) ext2 hurd partition.

What is the problem and how can I fix it?

I'll be glade to give more info,



To UNSUBSCRIBE, email to debian-hurd-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org

 Philip Charles; 39a Paterson Street, Abbotsford, Dunedin, New Zealand
  +64 3 488 2818        Fax +64 3 488 2875        Mobile 025 267 9420
    philipc@copyleft.co.nz - preferred.          philipc@debian.org
 I sell GNU/Linux & GNU/Hurd CDs & DVDs.   See http://www.copyleft.co.nz

Reply to: