[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Booting The Debian GNU/Hurd get locked


After following this:


installation guide, I get this message at boot:

(this is what I see on the screen)

ide0 at 0x1f0-0x1f7, 0x3f6 on irq 14

ide1 at 0x170-0x177, 0x3f6 on irq 15


FDC is a post 1991 82077

Failed initialization of WD-7000 SCSI card!

EATAO, address 0x1f0 in use skipping probe.

EATAO, address 0x170 in use skipping probe.

ppa: Version 1.42

ppa: Probing port 03bc

ppa: Probing port 0378

...(and some other lines from ppa)..

scsi: 0 hosts.

scsi: detected total.

rtl8139.c:B1.23a ...


eth0: RealTek RTL81396 Fast Ethernet at 0xa00 IRQ 10, 0:e0:ud: 7:98:ca

Now the system lock. It's not responding.

I installed from debian-gnu-hurd-2004.12.30.tar.gz. I have ABIT NF7-S (nforce 2 with SCSI controller that is in no use) motherboard, WD800JB hard disc (ATA connected), the Debian GNU/Hurd is on hda1or hd0s1 (I hope :-) ), It's a 6 GB (maybe this is it?) ext2 hurd partition.

What is the problem and how can I fix it?

I'll be glade to give more info,



Reply to: