Network setup.

[Jonathan Daugherty <cygnus@cprogrammer.org>]

The hurd install guides say that I must watch carefully during boot to
see if my network card (a linksys card) is detected.  Is there no log
which I can check for the same messages?  That is, ifconfig shows no
interfaces other than lo.  If mach does not detect my card during
boot, must I rebuild the kernel -- or is there a way to dynamically
load a driver module?

Thanks!

-- 
    _  ,^.  _    
  ,'/ -' '- \`.  
 / |   \ /   | \   Jonathan Daugherty
|  |   | |   |  |
|   \_,' `._/   |  http://www.cprogrammer.org
|               |
 \             / 
  `.         .'  
    `--._.--'