C3000 with Firmware 5.0, sym0: still hangs
Hello!
Just dared to upgrade the firmware of my C3000 from 3.4 to 5.0
The firmware upgrade went fine (using a HP-UX 10.20 patch depot).
But the error is still the same, after installing debian
using sarge-hppa-netinst.iso and rebooting I get:
...
sym0: <896> rev 0x4 at pci 0000:00:0f.0 irq 65
sym0: No NVRAM, ID 7, Fast-40, LVD, parity checking
--- machine freezes ---
(e.g. pressing the soft-power-button doesn't reset the machine)
Normally the next line is
sym0: SCSI BUS has been reset.
Any ideas what to try next, e.g. are there any kernel parameters
I can try to set? (on i386 architecture I would try the various
acpi=off, apm=off, splash=off 'failsafe' parameters ...)
Erik
Reply to: