parisc boot failure caused by setserial
Package: setserial
Version: 2.17-33
Severity: grave
This is an A500. The boot breaks during the run of seterial. disabling
setserial lets the machine boot again.
Cleaning: /etc/network/ifstate.
Setting up IP spoofing protection: rp_filter.
Configuring network interfaces... done.
Starting portmap daemon: portmap.
Loading the saved-state of the serial devices...
Cannot set serial info: Device or resource busy
/dev/ttyS0 at 0x0040 (irq = 132) is a 16550A
************* SYSTEM ALERT **************
SYSTEM NAME: gsphppa
DATE: 09/24/2003 TIME: 22:05:03
ALERT LEVEL: 7 = reserved
REASON FOR ALERT
SOURCE: 0 = unknown, no source stated
SOURCE DETAIL: 0 = unknown, no source stated SOURCE ID: FF
PROBLEM DETAIL: 0 = no problem detail
LEDs: RUN ATTENTION FAULT REMOTE POWER
ON OFF OFF ON ON
LED State: System running normally.
0x0000007000FF6292 000000F0 F0000000 - type 0 = Data Field Unused
0x5800087000FF6292 00006708 18160503 - type 11 = Timestamp 09/24/2003 22:05:03
A: ack read of this entry - X: Disable all future alert messages
Anything else skip redisplay the log entry
->Choice:Timeout!
*****************************************
Reply to: