Re: woody install problems on c180
Hi Thaddeus,
Three options
Try serial console
Try booting with "video=stifb:off" as an additional parameter to palo
(havn't tried this myself, but it might work)
Try a newer ISO (official woody, or one from
http://pateam.esiee.fr/download.html), and maybe boot it with
"nolangchooser".
Richard
On Sat, Jul 20, 2002 at 09:06:22PM -0500, Thaddeus Wilson wrote:
> i get further with woody than with 0.9.3 release which isn't saying much for me at this point because i think i could have gotten the latter to work.
>
> i have a c180 with v6.2 firmware
> two hard drives id's 6 and 5
> 1 sescsi cd drive id 3
> i have hpux 10.20 on id 6 and intend to put debian on id 5
>
> i boot the install cd image number 1 i just burned and get started on the boot with the penguin at the top.
>
> it goes through a lot of messages recognizing hardware and the such and gets to a line with:
> "init started: busybox V0.60.3-pre......................mulit-call binary"
> then it hangs up with the screen going black
>
> note i do have the hrc-24 hp graphics card i think a4071b on the back of card as my graphics, but since i got the penguin i thought i was good to go for install.
>
> any ideas and sorry this is just one step up from newbie or to most of ya'll newbie, but i'd really like to use this box as a dual boot system.
>
> thanks in advance for any assistance
--
To UNSUBSCRIBE, email to debian-hppa-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: