Re: Boot problem
On Tue, Oct 09, 2001 at 07:29:28PM +0200, Albert Strasheim wrote:
> On Tue, 09 Oct 2001, Hamish Moffatt wrote:
> > After the ttyS0 port is initialised, I don't get any more console
> > output on the console port (when the card is installed, that is),
> > so that could be a problem.
> Sounds like the swapped serial port problem that got fixed in 2.4.9-pa20
> or thereabouts.
OK, I'll try that. Thanks.
I made a new CD using the instructions in the PALO README.. I copied
the contents of the 0.9.2 CD, replaced the kernel and iplboot,
mkisofsed, then paloed the CD image, but when I boot up this CD
it doesn't seem to load the RAM disk image, and then it can't
find the root file system on /dev/ram0. Any idea where I went wrong?
My kernel command line looks the same as when I boot the 0.9.2
Hamish Moffatt VK3SB <email@example.com> <firstname.lastname@example.org>